“Hello world” with DEBUG
Coding “Hello world” with DEBUG will be a blunt exercise on programming futility. Or an exercise on retro, old-school coding. More than two decades ago I used to code in x86 (Intel) assembly, almost daily. I remember the masochist approach to learning the opcodes and the hardware architecture. The famous RBIL (Ralf Brown’s Interrupt List) was, back then, my favorite “reference”. First painful steps were taken and first crashes happily followed. I remember trying to code, as expected, the traditional “hello, world!”, using a strange tool included in DOS, DEBUG.COM. I wrote a post about this “hello, world” with DEBUG.COM elsewhere, and yesterday I found the time to reread it: I verified, first with awe, then with horror, and finally, with relief, that I had almost completely forgotten how to code in assembly. So I’ll revisit this here, mostly as a self-imposed disciplinary measure, an exercise on programming, specifically, an exercise on programming futility. Heck, DEBUG isn’t even available on the Windows 10 machine I’m typing this on. However, DEBUG looked pretty cool back then: it could assemble, disassemble and dump hexadecimal output. You could create little programs, or inspect programs and peek memory areas.
Specifically what I want is to build a minimal “hello, world!” program using DEBUG.COM. I don’t have any use for this, but it comes as a “relaxing” post after several weeks focused on the release of “DragonScales 3: Eternal Prophecy of Darkness” on Steam and the localization of “DragonScales 5: The Frozen Tomb”. After we execute DEBUG.COM we’ll meet a prompt with a “-” symbol. Now we can input our commands. I want to assemble, i.e., I want to type assembly language instructions. The command for that is “a”, which might be optionally followed by a memory address. By default, instructions will be placed starting from CS:0100, so I’ll use that address. Equivalently, I could type “a 0100” or “a 100” to achieve the same result.
-aNow we have to place the data in memory. For this little program I only need the characters for “hello, world!!”. Notice I want two “!!” at the end. That’s because I want the final program to occupy exactly 32 bytes; we’ll see the reason for this later on. I’ll use the pseudo-instruction “DB” to define our string. With DB I can neatly provide the string using ASCII values, like this:
db "hello, world!!"Those are 14 bytes. However, I want a prettier output, with a newline character before and after our string. A newline is in fact two characters: a carriage return (CR is ASCII 13) and a line feed (LF is ASCII 10). In hexadecimal, CR is 0Dh, and LF is 0Ah. OK. Now our DB would be modified to look like this:
db 0d,0a,"hello, world",0d,0aThose are 18 bytes. We are not done yet with our data. In order to effectively print the message to the standard output I’ll recur to the function 09h of INT 21h. Check RBIL D-2109. In short, I have to place the value 09h in register AH, and DS:DX should point to the beginning of our string. The function will print every character until finding a “$” character (i.e., “$” acts as the “zero” in null-terminated C strings). ASCII value of “$” is 36, or 24 in hexadecimal. Therefore, we modify our DB instruction again:
db 0d,0a,"hello, world",0d,0a,"$"